Epox WT is a two component water based food grade epoxy system specially formulated for water proofing of water tanks. It is odorless, non toxic, non flammable and eco- friendly. Unlike pure epoxy resins, it can also be applied on damp surfaces.

  • Description


Technical Data

Resin Appearance White Colour
Hardener Appearance Yellow Colour
Film Appearance Transparent glossy
Pot Life 45 min at 35c
Coverage 35-40 Sq.ft per Kg/mix
Shelf life 12-15 months in original packing

Application Procedure

1. Clean the surface with water to make it free from dust, grease, oil etc.
2. If cracks are observed, widen it and fill it with Poly bond Acro & cement putty.
3. In a clean vessel, mix one part of resin & one part of hardener by weight. Stir it slowly to achieve a homogeneous mix. If viscosity of mix is higher add little water (5-10%) and stir properly.
4. Apply two coats with a brush in an interval of 24 hours.
5. Fill the tank with water after 24 hours.


1. Prepare adequate of material, which can be used in 30 minutes.
2. Wash the brush immediately after use.
3. Don’t retamper the mix with water again & again.


1. It is non-toxic & non-flammable.
2. It is self curing. No additional curing method is required.
3. Can be safely used in contact with drinking water.


In water tanks

Packing: ½ Kg, 1Kg, 4Kg (each component)

The information given is true to the best of our knowledge. They are offered in good faith but without guarantee as conditions and methods of use of all our products are beyond our control. Users are requested to determine the suitability of our material before adopting them on a commercial scale.